Miami Boat Lifts
BOATHOUSE SIDE MOUNT BRACKET
Used to mount boat lift on the side of a piling inside a boat house. Sold in sets of 4.
CABLE KEEPER
Designed to keep the cable running in the grooves, very helpful for rough water situations. These are optional on any 4-Post or 8-Post lift.
WALKWAY
Used to allow greater access to your boat for boarding and cleaning. Standard size is 15.5 inches wide or 12” wide with lengths up to 24′ long.
STAIRS/STEPS
Made to give even greater access to your boat and to attach to our standard walkways. Standard sizes: 2 Step, 3 Step, 4 Step (8 inch step rise). Larger sizes are available upon request we can even add hand rails if required.
STERN PLATFORM
Made to provide access to your out drives or motors. Standard length is 16′
STRINGER BRACKET
Lorem ipsum dolor sit amet, consectetur adipiscing elit. Ut elit tellus, luctus nec ullamcorper mattis, pulvinar dapibus leo.
BOARDING PLATFORM
Used to mount boat lift on the side of a piling inside a boat house. Sold in sets of 4.
TIDE GUIDES
Designed to keep the cradle in place in high current situations. Mounted on all four comers of your cradle beams, they will follow the piles keeping the cradle in place.
TOP BEAM COVERS
Commonly used in a low profile installation so that the top beam can be used as a walk platform. Made to fit each specific lift size.
REMOTES
For added convenience a remote control gives you the ability to put the boat on the lift while you are still in the boat. As an option you can also add auto-stop to this remote which will stop the boat lift at the pre-set height and depth. We offer both Gem and Tiger Shark Remotes.
HINGED FOLDING PLATFORM
Our hinged folding platforms are offered in three standard sizes but can be made custom to fit your boat lift application and made to fit both your sea-wall and dock. This platform gives you the ability to board your vessel and close the gap or extended distance between your boat and dock or sea-wall. The platform also folds up and locks into place so it can be out of the way when needed.
SHALLOW WATER CRADLES
In some instances, customers can run into shallow water situations on either one side or both sides of the boat where the lift is being installed. This creates an issue for lowering the lift all the way down before hitting the bottom. If this is the case, we have the solution. Our cradle systems can be custom made to be angled on one side or both sides to handle your water depth situation.